| Item information | Value |
|---|---|
| Category: | Type 2871 Direct-acting 2-way standard proportional valve |
| Valve seat seal material: | FKM (fluororubber) |
| Operation: | direct-acting |
| Nominal pressure max: | 12 bar |
| Port connection 1 type: | Internal thread |
| Kv value (water): | 0,018 m3/h |
| Electrical connection type: | Wire strand |
| Main valve orifice size 1 (P) (mm): | 0,8 mm |
| Main valve media-contacting material: | Stainless steel |
| Voltage min / nominal voltage: | 24 V |
| Port connection 1 thread marking: | 1/8 |
| Degree of protection IP (max. with suitable connection): | IP65 |
| Nominal power: | 5 W |
| Item weight: | 0,14 kg |
Direct-acting 2-way standard proportional valve
The direct-acting proportional valve Type 2871 is used as the regulating unit in control loops. Due to an elastomeric seat seal the valve closes tight (integrated shut-off function) ,up to the DN specific nominal pressure. The plunger of the valve is assembled frictionless, which leads to an extraordinary adjustment characteristic. This valve is particularly suitable for demanding control tasks (high control range, dry gases, etc.).
Technical data
Function (9)
| Type | 2871 |
| Valve function | A - normally closed - inlet port 1 (P/NC) |
| Fluidic port connection quantity | 2 |
| Valve function quantity switch positions | 2 |
| Operation | direct-acting |
| Main valve function principle | Globe valve |
| Switch function | proportional |
| Flow direction | Below seat |
| Installation position | any |
Orifice & flow (5)
| Main valve orifice size 1 (P) (mm) | 0,8 mm |
| Main valve orifice size 1 (inch) | 1/32 inch |
| Kv value (water) | 0,018 m3/h |
| QNn value (gas) | 19 l/min |
| Control range | 1:100 |
Pressure & temperature (7)
| Nominal pressure min | -1 bar |
| Nominal pressure max | 12 bar |
| Differential pressure max | 12 bar |
| Medium temperature min | -10 °C |
| Medium temperature max | 90 °C |
| Environment temperature min | -10 °C |
| Environment temperature max | 55 °C |
Line connection (6)
| Port connection 1 type | Internal thread |
| Port connection 1 thread type | G |
| Port connection 1 thread marking | 1/8 |
| Port connection 2 type | Internal thread |
| Port connection 2 thread type | G |
| Port connection 2 thread marking | 1/8 |
Materials (10)
| External sealing material | FKM (fluororubber) |
| Valve seat seal material category | Elastomers |
| Valve seat seal material | FKM (fluororubber) |
| Main valve media-contacting material | Stainless steel |
| Media-contacting part core material | Stainless steel |
| Media-contacting part stopper material | Stainless steel |
| Media-contacting part core guide tube material | Stainless steel |
| Media-contacting part core guide element 1 material | Stainless steel |
| Media-contacting part core guide element 2 material | PEEK (Polyetheretherketone) |
| Media-contacting part spacer sleeve material | Stainless steel |
Actuator & coil (10)
| Actuator type | Plunger valve |
| Core guide | Shaped spring |
| Core guide 2 | Bush |
| Coil type | block bolted |
| Coil insulation material (encasement) | Epoxy |
| Coil size | 20 mm |
| Coil resistor | 82 Ohm |
| Thermal insulation class of the actuator | H |
| Nominal power | 5 W |
| Nominal operating mode / duty cycle | 100 % |
Electrical (20)
| Voltage min / nominal voltage | 24 V |
| Voltage max / nominal voltage | 24 V |
| AC voltage | No |
| DC voltage | Yes |
| Voltage tolerance positive | 10 % |
| Voltage tolerance negative | 10 % |
| Degree of protection IP (max. with suitable connection) | IP65 |
| Electrical connection type | Wire strand |
| Electrical connection number of contacts | 2 |
| Electrical connection design | male |
| Cable plug in scope of delivery | not included |
| Electrical connection cable length | 500 mm |
| Electrical connection material | FEP (Fluorinated ethylene-propylene copolymer) |
| Electrical connection strand 1 colour | white/blue |
| Electrical connection strand 2 colour | white/blue |
| Electrical connection cable cross-section (AWG) | AWG 24 |
| Electrical connection cable cross-section (mm²) | 0,55 mm² |
| Electrical connection position | via inlet |
| PWM frequency min. | 800 Hz |
| PWM frequency max. | 1.000 Hz |
Versions (7)
| Vacuum variant | No |
| Analysis variant | No |
| Oxygen variant | No |
| Steam variant | No |
| Media separation | No |
| suitable for liquid media | Yes |
| suitable for gaseous media | Yes |
Shipping & customs (4)
| Weight | 0,135 kg |
| Customs tariff number | 84818079 |
| Country of origin | Germany |
| Export | Not subject to export licensing |
Product benefits
- Excellent range
- Very good response
- Compact valve design
- Orifice sizes 0.05 ... 2.0 mm
- Port connection 1/8” or sub-base
Your Benefits With Us
- Worldwide shipping of all valves and flow meters
- Large stock levels for many products – current lead time available on request
- Spare parts and service kits available
- Fast shipping via UPS (parcel) or freight forwarder (pallets), express delivery available on request
- Extensive hands-on application know-how
- Personal advice on selecting the right component
- Resellers receive volume-based discounts on request
- Large companies, public authorities and government agencies can order on account (request via our contact form)
Christian Bürkert GmbH & Co. KG, Christian-Bürkert-Straße 13-17, 74653 Ingelfingen, Baden-Württemberg, Deutschland, [email protected]
Manufacturer according to GPSR
Christian Bürkert GmbH & Co. KG, Christian-Bürkert-Straße13-17, 74653 Ingelfingen, Baden-Württemberg, Deutschland, [email protected]
