Tipo 5282 - Valvola servoassistita a membrana a 2/2 vie (329336)

Codice articolo: BUR.329336

HAN: 329336

Categoria: Tipo 5282 - Valvola servoassistita a membrana a 2/2 vie

scarsa disponibilità in magazzino

661,64 €

compr. 19% IVA , (Paket)

La 5282 è una valvola servoassistita a membrana. Per il funzionamento della valvola è necessaria una pressione differenziale minima. Sono disponibili svariate combinazioni di materiali della membrana e del corpo e funzionamenti diversi. Il corpo standard in ottone soddisfa tutti i requisiti europei in materia di acqua potabile. I corpi valvola sono disponibili in acciaio inox e ghisa grigia. La funzione della valvola può essere commutata facilmente da NC a NO mediante la rotazione del pilota 3/2 vie. Le bobine magnetiche sono rivestite con resina epossidica resistente agli agenti chimici applicata a pressione. La 5282 è dotata di un comando manuale utile per la messa in servizio e i test. Con l'utilizzo di un connettore conforme alla normativa DIN EN 175301-803 forma A, le valvole soddisfano i requisiti di NEMA 4X.

Valvola servoassistita a membrana con diametro nominale fino a DN 65
Membrana di separazione per fluidi aggressivi e contaminati
Tempi di apertura e chiusura impostabili individualmente
Versioni antideflagranti (Cat. 2)
Azionamento manuale di facile utilizzo

Seat seal material:	FKM (Fluor rubber)
Port connection 1 DN:	Inner thread-1 1/4-NPT
Voltage max / rated voltage:	120 V
Nominal pressure min:	0,2 bar
Operation:	servo-controlled
Valve function:	A - normally closed - inlet port 1 (P/NC)
Nominal pressure max (liquid):	10 bar
Temperatura del fluido:	0 °C-90 °C
Fluidic port connection number:	2
Valve function number of switching positions:	2
Valve function:	A - normally closed - inlet port 1 (P/NC)
Manual actuation:	Yes
Manual actuation type:	Key button
Port connection 1 type:	Inner thread
Port connection 1 thread marking:	1 1/4
Manual actuation stop:	Yes
Port connection 1 thread type:	NPT
Port connection 2 type:	Inner thread
Port connection 2 thread type:	NPT
Port connection 2 thread marking:	1 1/4
Tipo:	5282
Voltage min / rated voltage:	120 V
Voltage max / rated voltage:	120 V
Voltage frequency:	60 Hz
Voltage tolerance positive:	10 %
Voltage tolerance negative:	10 %
AC voltage:	Yes
DC voltage:	No
Battery voltage:	No
Main valve wetted material:	Brass
Back-pressure-resistant version:	No
Nominal pressure min:	0,2 bar
Pilot control material medium-contacting:	Brass
Nominal pressure max (liquid):	10 bar
Temperature medium min:	0 °C
Temperature medium max:	90 °C
Temperature environment max:	55 °C
Seat seal material category:	Elastomer
Seat seal material:	FKM (Fluor rubber)
Sealing toward outside material:	FKM (Fluor rubber)
Rated power consumption:	8 W
Kv value (water):	20 m3/h
QNn value (gas):	22.000 l/min
Pilot control seal material:	FKM (Fluor rubber)
Main valve orifice 1 (P) (mm):	32 mm
Main valve orifice 1 (inch):	1 1/4 inch
Pilot control orifice (mm):	2 mm
Actuator type:	Pivot
Operation:	servo-controlled
Media separation:	Yes
Main valve operating principle:	Diaphragm valve
Valve construction:	Valve complete
Switch function:	on/off
Switch time open min:	100 ms
Switch time open max.:	800 ms
Switch time close min:	1.000 ms
Electrical connection polarity:	Irrelevant
Switch time close max.:	4.000 ms
Nominal operation/Duty cycle:	100 %
Vacuum version:	No
Analysis version:	No
Oxygen version:	No
Valve setting opening time:	Yes
Valve setting closing time:	Yes
Oil burner valve:	No
Steam version:	No
Installation length:	126 mm
Main valve with integrated screen:	No
Electrical connection sort:	Plug pattern form A according to DIN EN 175301-803
Electrical connection number of contacts:	2 + Grounding conductor
Cable plug in delivery:	enclosed
Electrical connection position:	top
Cable plug art. no. - type:	00137943 - 2509
Protection type (IP max. with suitable connector):	IP65
Low-noise version:	No
Coil type:	block bolted
Coil insulation material (encasement):	Epoxy
Coil wiring overvoltage protection:	without
Coil wiring rectifier:	No
Coil wiring polarity recovery diode:	No
Thermal insulation class of the actuator:	H
inrush power consumption AC:	30 V·A
Rated power AC:	15 V·A