| Item information | Value |
|---|---|
| Category: | Valves |
| Seat seal material: | NBR (Nitrile rubber) |
| Line connection 1: | Inner thread-3/8-G- |
| Voltage max / rated voltage: | 24 V |
| Nominal pressure min: | 0,2 bar |
| Operation: | servo-controlled |
| Valve function: | A - normally closed - inlet port 1 (P/NC) |
| Nominal pressure max (liquid): | 16 bar |
| Temperature medium: | -10 °C-80 °C- |
| Fluidic port connection number: | 2 |
| Valve function number of switching positions: | 2 |
| Valve function: | A - normally closed - inlet port 1 (P/NC) |
| Manual actuation: | No |
| Port connection 1 type: | Inner thread |
| Port connection 1 thread marking: | 3/8 |
| Port connection 1 thread type: | G |
| Port connection 2 type: | Inner thread |
| Port connection 2 thread type: | G |
| Type: | 6281 |
| Port connection 2 thread marking: | 3/8 |
| Voltage min / rated voltage: | 24 V |
| Voltage max / rated voltage: | 24 V |
| Voltage tolerance positive: | 10 % |
| Voltage tolerance negative: | 10 % |
| AC voltage: | No |
| DC voltage: | Yes |
| Battery voltage: | Yes |
| Main valve wetted material: | Brass |
| Back-pressure-resistant version: | No |
| Nominal pressure min: | 0,2 bar |
| Nominal pressure max (liquid): | 16 bar |
| Temperature medium min: | -10 °C |
| Temperature medium max: | 80 °C |
| Nominal pressure (DIN EN 1333): | PN 16 |
| Temperature environment max: | 55 °C |
| Seat seal material category: | Elastomer |
| Seat seal material: | NBR (Nitrile rubber) |
| Sealing toward outside material: | NBR (Nitrile rubber) |
| Rated power consumption: | 8 W |
| Kv value (water): | 3,8 m3/h |
| QNn value (gas): | 4.100 l/min |
| Main valve orifice 1 (P) (mm): | 13 mm |
| Pilot control seal material: | NBR (Nitrile rubber) |
| Main valve orifice 1 (inch): | 1/2 inch |
| Actuator type: | Plunger valve |
| Pilot control orifice (mm): | 1,2 mm |
| Operation: | servo-controlled |
| Media separation: | No |
| Flow: | Above seat |
| Main valve operating principle: | Diaphragm valve |
| Generation: | EV |
| Valve construction: | Valve complete |
| Switch function: | on/off |
| Switch time open min: | 50 ms |
| Switch time open max.: | 1.000 ms |
| Switch time close min: | 120 ms |
| Switch time close max.: | 3.000 ms |
| Nominal operation/Duty cycle: | 100 % |
| Vacuum version: | No |
| Analysis version: | No |
| Oxygen version: | No |
| Valve setting opening time: | No |
| Valve setting closing time: | No |
| Oil burner valve: | No |
| Steam version: | No |
| Installation length: | 58 mm |
| Main valve with integrated screen: | No |
| Electrical connection sort: | Plug pattern form A according to DIN EN 175301-803 |
| Electrical connection number of contacts: | 2 + Grounding conductor |
| Cable plug in delivery: | not included |
| Electrical connection position: | in direction of flow left |
| Pilot control centrally bolted: | Yes |
| Low-noise version: | Energy saving technology possible |
| Coil type: | No |
| Coil insulation material (encasement): | placed on top |
| Coil size: | PA (Polyamide) |
| Coil wiring overvoltage protection: | 32 mm |
| Coil wiring rectifier: | without |
| Protection type IP (max. with suitable connector): | IP65 |
| Coil wiring polarity recovery diode: | No |
| Thermal insulation class of the actuator: | No |
| Medium-contacting part core material: | 8 W |
| Medium-contacting part stopper material: | Stainless steel |
| Rated power DC: | B |
| Reduced power DC: | 9,5 W |
The 6281 valve is a servo-assisted solenoid valve of the S.EV series. A minimum differential pressure is always required for the function of the valve. Various diaphragm material combinations and methods of operation are available depending on the application. The standard brass housing satisfies all European drinking water requirements. Dezincification-resistant brass is available for other markets. The housing offering is rounded out by a stainless steel version. To reduce power consumption in operation, coils with "Kick and Drop" (KD) electronics assembly (double coil technology) are available. The valve can be equipped with manual override for easy maintenance and commissioning. NEMA 4X is available on request.
- Servo-assisted diaphragm with diameter of up to DN50
- Vibration-proof, central screwed coil system
- Damped design for quiet closing
- Energy-saving double coil technology with kick and drop variant
- Explosion-proof versions
Christian Bürkert GmbH & Co. KG, Christian-Bürkert-Straße 13-17, 74653 Ingelfingen, Baden-Württemberg, Deutschland, [email protected], https://www.buerkert.de
Manufacturer according to GPSR
Christian Bürkert GmbH & Co. KG, Christian-Bürkert-Straße13-17, 74653 Ingelfingen, Baden-Württemberg, Deutschland, [email protected], https://www.buerkert.de
